Launching A Project; Connecting To The Sensor With Sysmac Studio Measurement Sensor Edition - Omron ZW-7000 Series User Manual

2-6 Launching a project

Connecting to the sensor with Sysmac Studio Measurement Sensor Edition

Creating a new project
Create a new project, add a sensor to the project, then start communicating with the sensor.
1
Start up the PC tool.
2
Create a new project.
Click [New Project] and select [Displacement
Sensor] from [Category] under [Select Device],
and [ZW] from [Device].
Then enter [Project name], [Author], and
[Comment].
Click [Create] to create a blank project.
Note
If there are existing projects, click [Open Project].
A list of the projects is displayed. Select the proj-
ect you want to open and click [Open].
If an existing project is opened, it starts up in
offline mode. For the details of offline mode, see
below.
Chapter 6 Offline Settings p.181
3
Specify the sensor to connect using one of
the methods below.
• Directly specify the IP address of the sensor to
connect.
Check the [Specify a sensor] box.
Directly enter the IP address. Click [Confirm],
and then click [OK].
• When not connected with the sensor (offline)
When setting a project offline without
connecting to the actual sensor, check [Enter
the type] to select.
Then, select the sensor model and software
version to use and click [OK].
Chapter
Note
By default, the Sensor Controller has an IP address of 192.168.250.50
3 Basic Operation p.87
ZW-7000/5000
User's Manual
6 Offline Settings p.181
79

Launching a project