Omron ZW-7000 Series User Manual page 58

2
Connect the Fiber cable and Cariblation ROM to the Sensor Controller.
l
ZW-7000 Series
Mate the convex section on the fiber connector with the groove on the fiber adapter.
Make sure to have the bush section of the Fiber cable when you connect to the Fiber cable.
Cariblation
ROM
Fiber cable
Reference
If the resolution of PC is low, the light reception wave
might not be displayed. In this case, close displayed
item, measurement result, LED light and I/O input.
When install the Fiber cable
In right figure, have the bush section of fiber cable.
Mate the convex of fiber connector with the groove on
the fiber adapter.
Important
If you have connector section of Fiber connector, cannot be connected correctly.
56
Installation
Groove of fiber
adapter
Fiber connector
Convex of fiber connector
Fiber
adapter
Convex of fiber
connector
Bush section
ZW-7000/5000
User's Manual