Omron ZW-7000 Series User Manual page 284

5
Check the content of the message, and click
[OK].
The firmware update is started.
A progress bar is displayed during update
processing. Wait for the successful end
message box to be displayed. (The update takes
several minutes to complete.)
Important
• Errors may occur on the Sensor Controller
during updating, but just wait for the update to
complete.
• If the update progress bar stops midway or the
update does not end even after ten minutes,
there is the possibility that the update has failed.
In this case, contact an OMRON branch or sales
office about the firmware version before the
update and the one in the write file.
6
When the update is successfully completed,
a message appears. Click [OK].
7
Click [Finish] and exit Warp Engine ZW-7.
282
Firmware Update ZW-7000/5000
User's Manual