2-2 Part Names and Functions
The following describes the names and functions of parts of the Sensor Head, Calibration ROM and Sensor
Controller.
Sensor Head
l ZW-S70@0
3
2
1
No.
Names
1
Projector/receiver
2
Serial number.
3
Fiber interface
4
Fiber Cable
5
Fiber Connector
Calibration ROM
This ROM is associated with the sensor on a one-to-one basis, and operates connected to the Sensor
Controller.
No.
Names
1
Serial number
Important
Use with the Calibration ROM always connected. If the Calibration ROM is not connected, the error message
"SYSERR" is shown in the main digital and "NO.ROM" is shown in the sub digital, where measurement is not
possible.
If the Calibration ROM is lost, or fails, refer to p.174.
"6-1 Error Messages" described in Displacement Sensor ZW-7000/5000 series Confocal Fiber Type
Displacement Sensor User's Manual for Communications Settings (Z363)
ZW-7000/5000
User's Manual
l ZW-S50@0
5
4
Functions
Projects and receives light.
Serial number.
Only a calibration ROM with the same serial number is available.
Interfaces the Sensor Head and optical fiber.
(Do not remove this fiber interface. If you remove it, repair may be needed.)
Sends or receives light signals to/from the Sensor Controller.
Couples the Sensor Controller and fiber cable.
Functions
Serial number.
Only a Sensor Head with the same serial number is available.
4
3
2
1
1
5
Part Names and Functions
43