Resolving The Block Configuration Errors; Table 32: Resolving Block Configuration Errors - Honeywell SLG 700 Option Manual

Resolving the block configuration errors

Table 35 lists the parameters of all the blocks that can cause the status bit of Block Configuration
Error to be set in their respective BLOCK_ERR parameters. The following table provides the
initial values and the valid range for the parameters.
Parameter
ALERT_KEY
SIMULATE
XD_SCALE
OUT_SCALE
CHANNEL
L_TYPE
PV_FTIME
ALARM_HYS
HI_HI_PRI,
HI_PRI,
LO_LO_PRI,
LO_PRI
HI_HI_LIM,
HI_LIM
LO_LIM,
LO_LO_LIM
BYPASS
SHED_OPT
HI_HI_LIM
HI_LIM
LO_LIM
LO_LO_LIM
OUT_HI_LIM
OUT_LO_LIM
Rev.5
Table 35: Resolving block configuration errors
Initial Value
0 non-zero
1 (disabled) 1-2 (disabled -
enabled)
0 to 10m EU_100 > EU_0,
UNITS_INDEX
matches output of
transducer block
0 to 10m EU_100 > EU_0
0 1-13
0 (Uninitialize) 1,2,3 (direct, indirect,
sq. root)
0 0-200
0.5 (%) 0-50 (%)
0 0-15
+INF +INF or within
OUT_SCALE range
-INF -INF or within
OUT_SCALE range
0 1:OFF, 2:ON
0 1-8 see Shed Options
in the FF specs.)
+INF PV_SCALE, +INF
+INF
-INF PV_SCALE, -INF
-INF
100 OUT_SCALE
+/- 10%
0
FOUNDATION Fieldbus Option User's Manual
Valid Range
Initial Value is a configuration error.
Set value to non-zero number.
Set value in valid range.
Set values to valid range(s).
Set values to valid range.
Initial Value is a configuration error.
Set value to valid range.
Initial Value is a configuration error.
Set value to valid range.
Set value to valid range.
Set value to valid range.
Set value to valid range.
Set value to valid range.
Set value to valid range.
Initial value is a configuration error.
Set value in valid range.
Initial value is a configuration error.
Set value in valid range.
Values must be set in rank order.
For example, LO_LIM >
LO_LO_LIM but < HI_LIM etc.
Values must be set in rank order.
Verify that OUT_HI_LIM >
OUT_LO_LIM.
Corrective Action
Page 191