Verifying Communication With The Transmitter; Table 2: Transmitter Parameters - Honeywell SLG 700 Option Manual

2.2 Verifying communication with the transmitter

On the operator interface, establish communication with the device on the Fieldbus network. If the
device is not visible on the network, verify that the device has been installed properly.
2.2.1.
Verify the device identification of the transmitter by checking the device parameters. The parameters
contain the following information:

Transmitter type ( temperature transmitter, pressure transmitter, level transmitter and remote
meter)

Device Tag (tag description of the transmitter)

Sensor serial number

Firmware revision level (revision level of the firmware elements)
Check the transmitter parameters listed in Table 2 and note down the values to identify the transmitter.
ATTENTION
It is recommended to verify the correct version of the Device Description file is
present on the host computer. This helps in getting the correct parameter names
and its corresponding descriptions, while viewing the device parameters.
Resource block
DEV_TYPE
Device Tag
(Physical device tag name of the transmitter)
ATTENTION
The Device Tag name can be set and viewed
using the Fieldbus device configurator application.
Use a device tag name (up to sixteen characters)
that does not contain spaces.
Resource Block
SERIAL_NO
Resource Block
SOFTWARE_REV
Rev.5
Identify the transmitter

Table 2: Transmitter parameters

Parameter
FOUNDATION Fieldbus Option User's Manual
To verify
That the transmitter is of the proper
device type.
For all the SLG 700 SmartLine Guided
Wave Radar Level Transmitter, the value
is 0007
The Device Tag is correct.
Device Tag name
SMARTLINE_GWR_FF
This is the serial number of the FF
Transmitter which is obtained from the
Sensor housing. Check that the module
has a valid serial number.
This is the Software revision of the
Communication board. This may be
checked when instructed by Honeywell
TAC for troubleshooting.
Page 5