Honeywell SLG 700 Option Manual page 49

Parameter
FIELD_BACKGROUND_ADD_S
TATUS
FULL_TANK_DETECT
SENSOR_TYPE
SENSOR_SN
SENSOR_HW_REV
SENSOR_FW_VER
ASIC_SLOPE
ASIC_OFFSET
CHARACTER_DATE
MATERIAL_OF_CON_SEAL
MATERIAL_OF_CON_PROBE
DYNAMIC_BACKGROUND_UP
DATE
BACKGROUND_LENGTH
BACKGROUND_LENGTH_TYP
E
Rev.5
Can capture the additional status for the Field Background Add
Status parameter.
Additional Statuses:
Capture completed successfully without any error or
warning
Capture completed successfully but length had to be
trimmed due to short probe length
Capture completed successfully but length had to be
trimmed due to background buffer size
Capture completed successfully but a level peak was
included in the background
Capture cancelled by the user
Capture aborted due to invalid configuration
Capture aborted after multiple failed attempts
Capture aborted since reference reflection is not found
Capture failed due to non-volatile RAM write error
Full tank detection:
DISABLED
ENABLED
Displays Type of the Sensor. In this case it will display as Guided
wave sensor
Displays sensor serial number
Sensor Board Hardware Revision number
Sensor Board Firmware Version number
Displays ASIC_SLOPE
Displays ASIC_OFFSET
Characterization Date of the Level Sensor
Material of Construction of Seal
Material of Construction of Probe
Dynamic background update:
OFF
ON
The value can be between 0.0 toProbe length value (depending on
background type).
The Options are:
Level – background scan is done considering the Value provided
for background length as Product Level
Surface – background scan is done considering the value provided
for background length as distance to product
FOUNDATION Fieldbus Option User's Manual
Description
Page 33