Attributes - Honeywell SLG 700 Option Manual

Parameter
FD_CHECK_MASK
FD_CHECK_ACTIVE
FD_CHECK_ALM
FD_SIMULATE
HARDWARE_REV
SOFTWARE_REV
COMPATIBILITY_REV
MODEL_KEY
MOD_PART_1
MOD_PART_2
HW_SIMULATE_JUMP
ER_STATE
INSTALL_DATE
MAINTENANCE_MODE
SERIAL_NO
COMM_SERIAL_NO

Attributes

Supported Modes
Alarm Types
Rev.5
Mask of CHECK_ALM. It corresponds to the bit of bit to
CHECK_ACTIVE. A bit on means that the condition is masked out
from alarming.
Enumerated list of check conditions within a device.
Alarm indicating check alarms. These conditions do not have a direct
impact on the process or device integrity.
When simulation is enabled, the Field Diagnostics conditions are
taken from Diagnostic Simulate Value, or else the conditions are
taken from Diagnostic Value.
The hardware revision number of the communications module.
The software revision number of the communications module.
The compatibility revision number of the communications module.
The key number of SLG 700 level transmitter (Example: SLG 700).
First part of the Material of Construction Information.
Second part of the Material of Construction Information.
State of Hardware Simulation Jumper (Enabled / Disabled).
The date and time when the device is installed in the field. The date
and time is directly acquired from the FF Host.
It indicates whether device is ready for maintenance.'Chk with Oper'-
Check with operator to determine availability. 'Avail for Maint'- The
device is available for maintenance.
Serial number of the device.
Serial Number of the Communication Module.
The block supports the following modes:

AUTO (Automatic)

OOS (Out of Service).
The block supports standard block alarms (see section 3.2), and
added to it, a discrete alarm for write lock.
FOUNDATION Fieldbus Option User's Manual
Description
Page 25