Output Sequence Editor Commands - Honeywell Solaris 7980g User Manual

4. Character Match Sequences
5. End Output Sequence Editor
Other Programming Selections
If you are creating an output sequence using bar codes, scan
exit without saving any output sequence changes.

Output Sequence Editor Commands

SEQBLK
SEQPRE
SEQSUF
SEQSEP
SEQTTS1
SEQIPR
SEQISU
SEQISE
TRGSTO
FF
Examples outlining how to use these commands are shown below.
Output Sequence Example 1 - Three Symbologies
56
prefixes, suffixes, or formatted characters as part of the length (unless using
9999).
On the ASCII Conversion Chart (Code Page
represents the character(s) you want to match. Make a note of the hex value for
the character(s). If you are using bar codes to create your output sequence, use
the Programming Chart
the ASCII characters. (99 is the universal number, indicating all characters.)
Use FF to terminate this string or to begin another output sequence. If you are
using bar codes, scan F F. Scan Save to save your entries.
Sequence editor start command.
Add prefix to complete output sequences.
Add suffix to complete output sequences.
Add separators to complete output sequences.
Transmit partial sequence.
Add prefix to partial output sequences.
Add suffix to partial output sequences.
Add separators to partial output sequences.
Timeout for partial output sequences.
Termination string.
1252), find the hex value that
to read the alphanumeric combination that represents
Discard (page 236) to
Solaris 7980g User Guide