High Priority Symbology; Low Priority Symbology; Preferred Symbology Time-Out - Honeywell Solaris 7980g User Manual

High Priority Symbology

To specify the high priority symbology, scan the High Priority Symbology bar code
below. On the
ity. Locate the Hex value for that symbology and scan the 2 digit hex value from the
Programming

Low Priority Symbology

To specify the low priority symbology, scan the Low Priority Symbology bar code
below. On the
Locate the Hex value for that symbology and scan the 2 digit hex value from the
Programming
If you want to set additional low priority symbologies, scan FF, then scan the 2 digit
hex value from the
up to 5 low priority symbologies. Scan Save to save your selection. Default = None

Preferred Symbology Time-out

Once you have enabled Preferred Symbology and entered the high and low priority
symbologies, you must set the time-out period. This is the period of time the scan-
ner will search for a high priority bar code after a low priority bar code has been
encountered. Scan the bar code below, then set the delay (from 1-3,000 millisec-
onds) by scanning digits from the
Default = 500 ms.
52
Symbology Charts, find the symbology you want to set as high prior-
Chart. Scan Save to save your selection. Default = None
High Priority Symbology
Symbology Charts, find the symbology you want to set as low priority.
Chart.
Programming Chart
Low Priority Symbology
Preferred Symbology Time-out
for the next symbology. You can program
Programming Chart, then scanning Save.
* Preferred Symbology Off
Solaris 7980g User Guide