Trigger Commands - Honeywell Solaris 7980g User Manual

Response:
This response indicates that the device's Codabar Coding Enable (CBRENA) is set
to 1, or on.
Example: What are the device's settings for all Codabar selections?
Enter:
Response:
This response indicates that the device's Codabar Coding Enable (CBRENA) is set
to 1, or on;
the Start/Stop Character (SSX) is set to 0, or Don't Transmit;
the Check Character (CK2) is set to 0, or Not Required;
concatenation (CCT) is set to 1, or Enabled;
the Minimum Message Length (MIN) is set to 2 characters;
the Maximum Message Length (MAX) is set to 60 characters;
and the Default setting (DFT) has no value.

Trigger Commands

You can activate and deactivate the scanner with serial trigger commands. First,
the scanner must be put in Manual Trigger Mode by scanning a Manual Trigger
Mode bar code
(page
deactivated by sending the following commands:
Activate:
Deactivate: SYN U CR
The scanner scans until a bar code has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see "Read Time-Out" on page 3-
41 for a description, and the serial command on
186
CBRENA1[ACK]
cbr?.
CBRENA1[ACK],
SSX0[ACK],
CK20[ACK],
CCT1[ACK],
MIN2[ACK],
MAX60[ACK],
DFT[ACK].
(page 41), or by sending a serial menu command for triggering
41). Once the scanner is in serial trigger mode, the trigger is activated and
SYN T CR
page 192).
Solaris 7980g User Guide