User-Specified Good Read Delay; Serial Trigger Mode; Read Time-Out - Honeywell Solaris 7980g User Manual

User-Specified Good Read Delay

If you want to set your own length for the good read delay, scan the bar code below,
then set the delay (from 0 - 30,000 milliseconds) by scanning digits from the
Programming

Serial Trigger Mode

You can activate the scanner by using a serial trigger command (see
Commands
has been read or until the deactivate command is sent. The scanner can also be set
to turn itself off after a specified time has elapsed (see
lows).

Read Time-Out

Use this selection to set a time-out (in milliseconds) of the scanner's trigger when
using serial commands to trigger the scanner. Once the scanner has timed out, you
can activate the scanner either by pressing the trigger or using a serial trigger
Solaris 7980g User Guide
* No Delay
Medium Delay (1,000 ms)
Chart, then scanning Save.
on page 186). When in serial mode, the scanner scans until a bar code
User-Specified Good Read Delay
Short Delay (500 ms)
Long Delay (1,500 ms)
Trigger
Read Time-Out, which fol-
41