Checkpoint
EAS Controller Settings
The following switch settings for a Checkpoint Counterpoint IX controller can be
used as a starting point, however, these settings should be tuned according to your
particular installation.
EAS Controller
Scan one of the following bar codes to select the EAS system that is attached to the
scanner. Default = Off.
EAS Mode of Operation
Scan one of the following bar codes to select the EAS mode you wish to use.
When Interlocked is selected, EAS tag deactivation is interlocked with bar code
scanning and transmission. When using Interlocked, you must set the timeout (see
below).
When Continuous on Enable is selected, EAS tag deactivation is on all the time.
Solaris 7980g User Guide
SW2
On
SW1
On
* Off
Sensormatic
1
2
3
4
5
1
2
3
4
5
6
6
Checkpoint Systems
153