Output Sequence Editor Commands - Honeywell Xenon XP 195 Series User Manual

1. If you are using barcodes to create your output sequence, scan
2. Code I.D.
3. Length
4. Character Match Sequences
5. End Output Sequence Editor
Other Programming Selections
If you are creating an output sequence using barcodes, scan Discard
exit without saving any output sequence changes.

Output Sequence Editor Commands

SEQBLK
SEQPRE
SEQSUF
SEQSEP
SEQTTS1
SEQSAT
SEQTIM
SEQIPR
Xenon XP User Guide
Sequence on page 108.
On the Symbology Charts
to apply the output sequence format. Make a note of the hex value for that
symbology. If you are using barcodes to create your output sequence, scan the
2 digit hex value from the
Specify what length (up to 9999 characters) of data output will be acceptable
for this symbology. Make a note of the length. If you are using barcodes to
create your output sequence, scan the 4 digit data length
beginning on page 311. (Note: 50 characters is entered as 0050. 9999 is a
universal number, indicating all lengths.) When calculating the length, you
must count any programmed prefixes, suffixes, or formatted characters as part
of the length (unless using 9999).
On the ASCII Conversion Chart (Code Page
that represents the character(s) you want to match. Make a note of the hex
value for the character(s). If you are using barcodes to create your output
sequence, use the Programming Chart,
alphanumeric combination that represents the ASCII characters. (99 is the
universal number, indicating all characters.)
Use FF to terminate this string or to begin another output sequence. If you are
using barcodes, scan F F. Scan Save to save your entries.
Sequence editor start command.
Add prefix to complete output sequences.
Add suffix to complete output sequences.
Add separators to complete output sequences.
Transmit partial sequence.
Define satisfactory subsets of full output sequence.
Timeout for sequence members when using SEQSAT.
Add prefix to partial output sequences.
on page 297, find the symbology to which you want
Programming Chart,
1252), page 300, find the hex value
beginning on page 311 to read the
Enter Output
beginning on page 311.
Programming Chart,
(page 312) to
105