Output Sequence Editor Commands - Honeywell Granit XP 199 i Series User Manual

5. End Output Sequence Editor
Other Programming Selections
If you are creating an output sequence using barcodes, scan Discard
exit without saving any output sequence changes.

Output Sequence Editor Commands

SEQBLK
SEQPRE
SEQSUF
SEQSEP
SEQTTS1
SEQSAT
SEQTIM
SEQIPR
SEQISU
SEQISE
TRGSTO
FF
Examples outlining how to use these commands are shown below.
Output Sequence Example 1 - Three Symbologies
In this example, you are scanning PDF417, Code 128, and Code 39 barcodes, but
you want the scanner to output Code 39 first, Code 128 second, and PDF417 third.
Set up the sequence editor with the following command line:
Granit XP User Guide
Use FF to terminate this string or to begin another output sequence. If you are
using barcodes, scan F F. Scan Save to save your entries.
Sequence editor start command.
Add prefix to complete output sequences.
Add suffix to complete output sequences.
Add separators to complete output sequences.
Transmit partial sequence.
Define satisfactory subsets of full output sequence.
Timeout for sequence members when using SEQSAT.
Add prefix to partial output sequences.
Add suffix to partial output sequences.
Add separators to partial output sequences.
Timeout for partial output sequences.
Termination string.
SEQBLK sequence editor start command
(page 292) to
105