Led - Good Read; Number Of Beeps - Good Read; Number Of Beeps - Error; Good Read Delay - Honeywell Solaris 7980g User Manual

LED – Good Read
The LED indicator can be programmed On or Off in response to a good read.
Default = On.
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same
number of beeps will be applied to the beeper and LED in response to a good read.
For example, if you program this option to have five beeps, there will be five beeps
and five LED flashes in response to a good read. The beeps and LED flashes are in
sync with one another. To change the number of beeps, scan the bar code below
and then scan a digit (1-9) bar code and the Save bar code on the
Chart. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or
error can be programmed from 1 - 9. For example, if you program this option to
have five error beeps, there will be five error beeps and five LED flashes in response
to an error. To change the number of error beeps, scan the bar code below and then
scan a digit (1-9) bar code and the Save bar code on the
Default = 5.

Good Read Delay

This sets the minimum amount of time before the scanner can read another bar
code. Default = 0 ms (No Delay).
40
* LED - Good Read On
Number of Good Read Beeps/LED Flashes
Number of Error Beeps/LED Flashes
LED - Good Read Off
Programming
Programming Chart.
Solaris 7980g User Guide