Honeywell Solaris 7980g User Manual page 199

Concatenation of Multiple Commands
Multiple commands can be issued within one Prefix/Storage sequence. Only the
Tag, SubTag, and Data fields must be repeated for each command in the sequence.
If additional commands are to be applied to the same Tag, then the new command
sequence is separated with a comma (,) and only the SubTag and Data fields of the
additional command are issued. If the additional command requires a different Tag
field, the command is separated from previous commands by a semicolon (;).
Responses
The device responds to serial commands with one of three responses:
ACK
ENQ
NAK
When responding, the device echoes back the command sequence with the status
character inserted directly before each of the punctuation marks (the period, excla-
mation point, comma, or semicolon) in the command.
Examples of Query Commands
In the following examples, a bracketed notation [ ] depicts a non-displayable
response.
Example: What is the range of possible values for Codabar Coding Enable?
Enter:
Response:
This response indicates that Codabar Coding Enable (CBRENA) has a range of val-
ues from 0 to 1 (off and on).
Example: What is the default value for Codabar Coding Enable?
Enter:
Response:
This response indicates that the default setting for Codabar Coding Enable
(CBRENA) is 1, or on.
Example: What is the device's current setting for Codabar Coding Enable?
Enter:
Solaris 7980g User Guide
Indicates a good command which has been processed.
Indicates an invalid Tag or SubTag command.
Indicates the command was good, but the Data field entry was out of
the allowable range for this Tag and SubTag combination, e.g., an
entry for a minimum message length of 100 when the field will only
accept 2 characters.
cbrena*.
CBRENA0-1[ACK]
cbrena^.
CBRENA1[ACK]
cbrena?.
185