User-Specified Reread Delay; Illumination Lights; Centering - Honeywell Solaris 7980g User Manual

User-Specified Reread Delay

If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights On
bar code, below. However, if you want to turn just the lights off, scan the Lights Off
bar code. Default = Lights On.

Centering

Use Centering to narrow the scanner's field of view to make sure that when the
scanner is hand-held, it reads only those bar codes intended by the user. For
instance, if multiple codes are placed closely together, centering will insure that
only the desired codes are read. (Centering can be used in conjunction with
Centering, page 49, for the most error-free operation in applications where multi-
ple codes are spaced closely together.)
Note: To adjust centering when the scanner is in Presentation Mode, see
Centering
Solaris 7980g User Guide
Long (1000 ms)
Chart, then scanning Save.
* Lights On
(page 3-45).
User-Specified Reread Delay
Extra Long (2000 ms)
Lights Off
Presentation
49