Presentation Mode; Presentation Idle Mode - Honeywell Solaris 7980g User Manual

command. After scanning the Read Time-Out bar code, set the time-out duration
(from 0-300,000 milliseconds) by scanning digits on the
scanning Save. Default = 30,000 ms.

Presentation Mode

Presentation Mode uses ambient light and scanner illumination to detect bar
codes. When in Presentation Mode, the LEDs remain dim until a bar code is pre-
sented to the scanner, then the LEDs turn up to read the code. Scan the following
bar code to program your device for Presentation Mode. Default = Presentation
Mode.

Presentation Idle Mode

When Presentation Idle Mode is selected, the scanner goes into idle mode (illumi-
nation dims) after the time interval set, during which there is no activity. Change
the Presentation Idle mode by scanning the bar code below, and then scanning
digits from the
3000000. The scanner will wake when an object is presented to the window or the
pitch or volume button is pressed. Default = 10000 (10s).
When Off is selected, no power saving is used and the scanner remains powered
on.
Note: In some conditions the scanner will switch between
Presentation Sleep Mode
wake up in very dark conditions.
Note: This selection is unavailable when the
Presentation Mode
42
Programming
are set to off.
Presentation Idle Mode
Read Time-Out
* Presentation Mode
Chart, then scanning Save. The range is 0 to
according to ambient light level. This allows the scanner to
Illumination Lights
Programming
Presentation Idle Mode
or LED Illumination -
Off
Solaris 7980g User Guide
Chart, then
and