Honeywell Solaris 7980g User Manual page 126

UPC-A On/Off
Note: To convert UPC-A bar codes to EAN-13, see
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted
at the end of the scanned data or not. Default = On.
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the begin-
ning of the scanned data, but can be programmed so it is not transmitted (Off).
Default = On.
112
* On
* On
* On
Convert UPC-A to EAN-13
Solaris 7980g User Guide
Off
on page 119.
Off
Off