Hdmi Connections - Extron electronics IN1608 xi IPCP SA with LinkLicense User Manual

HDMI Connections

Use an Extron LockIt cable lacing bracket to secure HDMI cables to the device. One bracket
secures up to two HDMI cables in a stacked formation (see figure 17), but each stacked
formation supports up to two brackets (one on each side) for added support if necessary.
Side Mounted
Figure 17.
To install a LockIt cable lacing bracket, perform the following:
1
2
1
Figure 18.
1. Loosen the side HDMI connection mounting screw (see figure 18,
enough space between the device and the screw head to fit the cable lacing bracket.
Do not remove the screw from the device.
2. Plug the HDMI cables into the panel connection (
3. Place the bracket on the screw and against the HDMI cables, and then tighten the
screw to secure the bracket (
ATTENTION:
•
•
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket (
5. While holding the connector securely against the lacing bracket, use pliers or a similar
tool to tighten the tie wrap, then remove any excess length.
Stacked
LockIt Cable Lacing Bracket Mounting Options
2
LockIt Cable Lacing Bracket Mounting Instructions
).
3
Do not overtighten the screw. The shield to which it is fastened is very thin and
can easily be stripped.
Ne serrez pas trop la vis. Le blindage auquel elle est attachée est très fin et
peut facilement être dénudé.
).
4
IN1608 xi Scaling Presentation Switcher • Installation
1
3
2
).
2
1
4
) so there is
1
22