Connection Details; Analog Video Wiring; Hdmi Connections - Extron electronics IN1606 User Manual

Connection Details

Analog Video Wiring

Pin RGBHV
1 Red
2 Green
3 Blue
4
5 H Sync Return
6 Red Return
7 Green Return
8 Blue Return
9
10 V Sync Return/
DDC Return
11
12 EDID/DDC
13 H Sync
14 V Sync
15 EDID/DDC

HDMI Connections

Pinout Table for 15-pin HD Connectors
RGBs
Red
Green
Blue
C Sync Return
Red Return
Green Return
Blue Return
DDC Return
EDID/DDC
C Sync Composite Video
EDID/DDC
Use an Extron LockIt Lacing Bracket to secure an HDMI
cable to each device.
1. Plug the HDMI cables into the panel connection.
2. Loosen the side HDMI connection mounting screw
from the panel enough to allow the LockIt lacing
bracket to be placed over it. The screw does not
have to be removed.
3. Place the LockIt lacing bracket on the screw and
against the HDMI connector, then tighten the screw
to secure the bracket.
ATTENTION: Do not overtighten the HDMI
connector mounting screw. The shield to
which it is fastened to is very thin and can
easily be stripped.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt
lacing bracket.
5.
While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length.
The LockIt bracket can also be used in a stacked formation, as shown below.
Side Mounted
Stacked
Figure 10. LockIt Bracket Mounting Options
IN1606 and IN1608 Series Scaling Presentation Switcher • Installation
RGBcvS Component
Red R-Y
Green Y
Blue B-Y
Sync Return
R-Y Return
Y Return
B-Y Return
S-video Composite
Luma Video
Chroma
L Return Video Return
C Return
5 1
15
11
1
2
3
4
12