Scan Speed Setting; Programmed Scan - Icom IC-PCR1500 Instruction Manual

8
SCAN OPERATION
I Scan speed setting
The searching speed of frequencies or memory channels is
variable.
➥ Click the [SPEED] control (on multi-function receiver
screen or component screen) to set the speed at which
scans search through frequencies/memories for signals.
• Right-click to increase the speed level.
• Left-click to decrease the speed level.
• When clicking and holding the control, the scan speed increases
or decreases continuously.
• When clicking and holding [SPEED], the scan speed scrolls up or
down.
51
I Programmed scan
Programmed scan automatically searches for signals within
a specified frequency range.
For programmed scan, scan edges must be programmed
in advance. See the next step for details.
D Setting scan edges
Settings such as frequency range, receive mode, tuning step,
etc. must be set in advance. Up to 50 settings can be pro-
grammed.
qRight-click the [PROG] button to call up the Program Scan
setting screen if it is not displayed.
wClick the [Program Scan] tab to show the program list.
eInput the start frequency into [Freq Low] cell from the key-
board, then push [Enter].
Other items are set automatically when [Freq Low] cell is
entered.
Program the start frequency first, otherwise no setting
can be done except for the name.
rSet data into other cells if desired, then click the close ([X])
button to close the setting screen.