Icom IC-PCR1500 Instruction Manual page 4

PRECAUTION
RWARNING RF EXPOSURE!
Frequency (RF) energy. Extreme caution should be observed when
operating this device. If you have any questions regarding RF expo-
sure and safety standards please refer to the Federal Communica-
tions Commission Office of Engineering and Technology's report on
Evaluating Compliance with FCC Guidelines for Human Radio fre-
quency Electromagnetic Fields (OET Bulletin 65).
RWARNING! NEVER
This may pose a fire hazard or result in an electric shock.
RWARNING! NEVER
vehicle. Safe driving requires your full attention—anything less may
result in an accident.
NEVER
connect the receiver to a power source of more than 16 V
DC. This will damage the receiver.
NEVER
connect the receiver to a power source using reverse po-
larity. This will damage the receiver.
NEVER
cut the DC power cable between the DC plug and fuse
holder. If an incorrect connection is made after cutting, the receiver
may be damaged.
NEVER
expose the receiver to rain, snow or any liquids. The re-
ceiver may be damaged.
NEVER
operate or touch the receiver with wet hands. This may
result in an electric shock or damage the receiver.
NEVER
place the receiver where normal operation of the vehicle
may be hindered or where it could cause bodily injury.
iii
This device emits Radio
connect the receiver to an AC outlet.
operate the receiver while driving a
NEVER
let objects impede the operation of the cooling fan on the
rear panel.
AVOID
using or placing the receiver in direct sunlight or in areas
with temperatures below –10°C (+14°F) or above +60°C (+140°F).
BE CAREFUL!
The receiver will become hot when operating it
continuously for long periods.
AVOID
setting the receiver in a place without adequate ventilation.
Heat dissipation may be affected, and the receiver may be damaged.
AVOID
the use of chemical agents such as benzine or alcohol
when cleaning, as they can damage the receiver's surfaces.
USE
Icom microphones only (supplied or optional). Other manu-
facturer's microphones have different pin assignments and may dam-
age the receiver if attached.
For U.S.A. only
CAUTION:
Changes or modifications to this device, not ex-
pressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.