Control Commands Relative To I/Q Port Setting; D Receive Frequency; D Receive Band Edge Frequency - Icom IC-R8600 Reference Manual

I/Q SIGNAL

■ Control commands relative to I/Q port setting

D Receive frequency

Command:
05
q w
X X X X X
L You can omit the upper digits entry. When omitted, the current frequency is applied.

D Receive Band edge frequency

D
Command: 1A 0F
PC to IC-R8600 (Write data format)
Specify the band edge to read by the edge number in a BCD code.
q
X X
Edge number: 0 1 to XX*
L The upper number (*marked) will be the returned value of command "1A 0E."
LIf the specified number exceeds the readable capacity, "NG (FA)" will be returned.
To read the number of the edge, send command "1A 0E" (The Read Receive Band Edge Count command).
IC-R8600 to PC (Read data format)
q w e r t
X X X X X X X X X X X X 2 D X X X X X X X X X X
Edge frequency (Lower)
L The upper number (*marked) will be the returned value of command "1A 0E."
L The lower edge frequency, separator (fixed to "2D") and upper edge frequency are returned as well as the Edge number.
e r t
X X X X
y u i o !0 !1
Edge frequency (Upper)
X
!2
10