Debug Platform Stack-Manager - Cisco Catalyst 2960-XR Reference

Stack Manager Commands

debug platform stack-manager

To enable debugging of the stack manager software, use the debug platform stack-manager command in
privileged EXEC mode. To disable debugging, use the no form of this command.
debug platform stack-manager {all| rpc| sdp| sim| ssm| tdm| trace}
no debug platform stack-manager {all| rpc| sdp| sim| ssm| tdm| trace}
Syntax Description
all
rpc
sdp
sim
ssm
tdm
trace
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS 15.0(2)EX1
Usage Guidelines
This command is supported only on stacking-capable switches.
The undebug platform stack-manager command is the same as the no debug platform stack-manager
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable debugging
on a stack member, you can start a session from the stack master by using the session switch-number EXEC
command. Enter the debug command at the command-line prompt of the stack member. You also can use
the remote command stack-member-number LINE EXEC command on the stack master switch to enable
debugging on a member switch without first starting a session.
OL-29435-01
Displays all stack manager debug messages.
Displays stack manager remote procedure call (RPC) usage debug messages.
Displays the Stack Discovery Protocol (SDP) debug messages.
Displays the stack information module debug messages.
Displays the stack state-machine debug messages.
Displays the stack manager topology discovery use debug messages.
Traces the stack manager entry and exit debug messages.
Catalyst 2960-XR Switch Stack Manager Command Reference, Cisco IOS Release 15.0(2)EX1

debug platform stack-manager

Modification
This command was introduced.
15