To Apply the Vertical Knobs
Use the vertical controls to display signal waveforms by adjusting the vertical
knob, and the
1.
Using vertical
The vertical
waveforms in all channels (excluding MATH and REF). The resolution changes
according to the vertical level set. Pressing this knob will clear the channel's
vertical offset to zero.
2.
Using vertical
The vertical
waveforms in all channels (excluding MATH and REF). If the Volts/Div is set to
"Coarse", the waveform scales in a 1-2-5 step sequence from 2
mV ,5mv,10mv...to 10 V. If the Volts/Div is set to "Fine", it scales to small steps
between the coarse settings. Turn the knob clockwise to decrease the vertical
scale, turn the knob counter-clockwise to increase the vertical Volts/Div setting.
You can toggle between "coarse" and "Fine" setting through pressing the
knob.
3.
Channels(excluding
vertical
4.
During the vertical positioning, a position message is displayed on the left
bottom of the screen, in the same color along with the corresponding channel.
The unit is V (Volts).
© 2008 RIGOL Technologies, Inc.
knob, and setting the input parameters.
knob.
control changes the vertical position of signal
knob.
control changes the vertical sensitivity of signal
Math
and
REF
and
only when they are selected.
User's Guide for DS1000B Series
would
be
adjustable
RIGOL
by
the
2-27