Pass/Fail - Rigol DS1102/4B User Manual

RIGOL

Pass/Fail

The Pass/Fail function monitors changes of signals and output pass or fail signals by
comparing the input signal which is within the pre-defined mask.
Press Utility Pass/Fail to go to the following menu.
Figure 2-93 Table 2-58 The Pass/Fail menu (Page 1/2)
Menu
Enable Test
Source
Operate
Msg display
Figure 2-94 Table 2-59 The Pass/Fail menu (Page 2/2)
Menu
Output
Stop
on Output
Mask Setting
*Note: The beeper should be opened.
2-76
Setting
ON Turn on Pass/Fail test.
OFF Turn off Pass/Fail test.
CH1, CH2, Select Pass/Fail test on CH1, CH2,
CH3, CH4 CH3 or CH4.
(RUN)
Pass/Fail test stopped, press to run.
■
Pass/Fail test running, press to stop.
(STOP)
ON Turn on Pass/Fail information display.
OFF Turn off Pass/Fail information display.
Settings
Fail Output when Fail condition detected.
Output and beep when Fail condition
Fail +
*
detected.
Pass Output when Pass condition detected.
Output and beep when Pass condition
Pass+ *
detected.
ON Stop test when output occur.
OFF Continue test when output occur.
Go to mask setting menu.
User's Guide for DS1000B series
Comments
Comments
© 2008 RIGOL Technologies, Inc.