Manual Mode - Rigol DS1102/4B User Manual

RIGOL

Manual Mode

Figure 2-130 Table 2-87 The Cursors menu
Menu
Mode
Type
Source
In this mode, the oscilloscope measures the Y or X coordinate values of the cursors,
and the increments between the two cursors.
To do manual Cursor Measurements, please do as the following steps:
1. Select the Manual mode for cursor measurement by pressing soft button as:
Cursor Mode Manual.
2. Select channel Source for measurements by pressing soft button as:
Cursor Source CH1, CH2, CH3, CH4, MATH.
NOTE: While measuring the channel with MATH, the results are valued with "d"
(division) as units.
3. Select the cursors type by pressing soft button as Cursor Type
4. Move the cursors to adjust the increment between the cursors:(Details in the
following Table)
2-100
Settings
Adjust the cursor to measure X/Y
Manual
parameters manually.
Shown as vertical line to measure the
X
horizontal parameters.
Shown as horizontal line to measure
Y
the vertical parameters.
CH1
CH2
CH3 Select the measurement signal source.
CH4
MATH
User's Guide for DS1000B series
Comments
X or Y.
© 2008 RIGOL Technologies, Inc.