To Perform A Functional Check - Rigol DS1102/4B User Manual

RIGOL

To Perform a Functional Check

Perform this quick functional check to verify that the instrument is operating
correctly.
1. Turn on the instrument.
¾
Use the power cord designed for the oscilloscope only.
¾
Use a power source that delivers 100 to 240 V, 45Hz to 440Hz.
¾
Turn on the instruments, and wait until the display shows the waveform window.
¾
Push the Storage button, select Storage in the top menu box and push the
Factory menu box, then continue pressing Load.
Power
!
WARNNING:
To avoid electric shock, be sure the oscilloscope is properly grounded.
2. Input a signal to a channel of the oscilloscope
Set the attenuation switch on the probe to 10X and connect the probe to Channel
1 on the oscilloscope.
To do this:
¾ Align the slot in the probe connector with the socket on the Bayonet Nut
Connector (BNC) connector of CH1 or CH2.
¾ Push to connect, and twist to the right to lock the probe in place.
¾ Attach the probe tip and ground lead to the PROBE COMP connector.
1-6
Figure 1-4
Turn on the instrument
User's Guide for DS1000B series
Storage button
© 2008 RIGOL Technologies, Inc.