To Set Up The Vertical System; To Set The Channels - Rigol DS1102/4B User Manual

RIGOL

To Set up the Vertical System

To Set the Channels

Each channel of DS1000B series digital oscilloscope has an independent operation
menu and it will pop-up after pressing any button among CH1, CH2, CH3, CH4. The
settings of all items in the menu are shown in the table below.
Figure 2-1 Table 2-1 The Channel menu (Page 1/2)
Menu
Coupling
BW Limit
Probe
Digital filter
2-2
Settings
AC Restraint the DC component of the
input signal and passes the AC
component with frequency higher
than 5Hz.
DC Passes
components of the input signal
GND Disconnect the input signal.
ON Limit the channel's bandwidth to
20MHz to reduce display noise.
OFF Get full bandwidth.
0.001X
Set up the oscilloscope's probe
.
attenuation factor to make the
.
vertical scale readout correct.
1000X
Set up digital filter (See table 2-4).
Go to the next menu page (The
1/2 followings are the same, no more
explanation).
User's Guide for DS1000B series
Comments
both AC and
© 2008 RIGOL Technologies, Inc.
DC