Probe compensator
Set the probe attenuation of the oscilloscope to 10X. To do this, push
CH1 Probe 10X.
Figure 1-6
Set the probe
Push the AUTO button. Within a few seconds, a square wave will be displayed on
the screen.
Push the OFF button or push the CH1 button again to turn off Channel 1.
Push the CH2, CH3, CH4 buttons to turn on channel 2, channel3, channel4, repeat
steps 2 and 3.
NOTE: The signal output from Probe compensator should only be used for probe
compensation, not for calibration.
© 2008 RIGOL Technologies, Inc.
Figure 1-5
Attach the probe
The CH1 menu
User's Guide for DS1000B Series
Probe scale
Figure 1-7
RIGOL
1-7