Table of Contents
Advertisement
GSMX4G / GSMXCN4G Installation and Setup Guide
Registering Using the 7720P Programming Tool
The interactive registration feature allows the installer to register the
communicator through a series of keyboard commands on the 7720P
Programming Tool. This method of registration lets the installer monitor the
registration process.
Once the installation is complete, press the [Shift] plus the
Registering
up arrow [↑] on the 7720P. The registration message is
...
sent and the unit waits for the acknowledgment.
If this is a new installation and the city, central station, and
Registration
customer numbers have been correctly entered, the commu-
SUCCESS
nicator is registered and this message is displayed. The
communicator is now in full service and available for alarm
reporting to the central station.
Possible Errors
Displayed if no response to the registration request is
Registration
received.
BAD
Timed Out
Indicates the city, central station, or customer number for
Registration
the labeled account(s) is not accepted. The ID information
BAD
was either entered in error, or the central station failed to
Pri Sub ID
pre-authorize programmed ID numbers with AlarmNet
BAD
customer service.
Displayed if this is a repair/replacement, or an error was
Registration
made in programming the Primary account information of
BAD
the communicator for an existing account. This prompt
Pri ID –
appears for 2 seconds. See the Replacing an existing
Need PIN
communicator topic.
Replacing an existing communicator
This prompt appears after pressing the down arrow [↓] on
Enter PIN#
the 7720P. Enter a 4-digit alphanumeric PIN number
provided by your central station, your dealer or an
authorized AlarmNet representative.
Press the [ENTER] key.
The registration message is sent and the unit waits for
Registering
acknowledgement.
...
– 28 –
Hide quick links:
Advertisement
Table of Contents
