Using A 7720P Programming Tool; Using The Control Panel Programming Mode - Honeywell IntelliPath Series Installation And Setup Manual

Section 3: Programming the Communicator

Using a 7720P Programming Tool

Connect the 7720P Programming Tool as shown below. The communicator powers the 7720P
Programming Tool via the programming jack, and automatically senses the presence of the
7720P when it is plugged in.
Each key of the 7720P has two possible functions: a normal function and a Shift function.
To perform a normal key function, simply press the desired key.
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. The table below lists
each normal and shift key function.
KEY
BS / ESC
 / 
N / Y
SHIFT
1 / A
2 / B
3 / C
4 / D
5 / E
6 / F
7 / S
8 / T
9 / X
SPACE
0
# / ENTER
* Active only when the "Exit Programming Mode" prompt is displayed.

Using the Control Panel Programming Mode

Most control panels support programming of the communicator through the control panel
programming mode (refer to the control panel's installation guide). If programming through the
control panel, only the ECP Mode programming options are available. The "mode" prompts will
not be displayed, and the mode cannot be changed. For a description of key functions on the
control panel keypad, and how they map to the 7720P Programming tool, refer to the control
panel's Programming Guide.
Xmit
Shift
BS / ESC
/
N / Y
Shift Space
7720P Programming Tool Connection
7720P Normal and Shift Key (shift LED lit) Functions
NORMAL KEY FUNCTION
[BS]: Press to delete entry
[]: Scroll down programming
[N]: Press for "NO" answer
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key
is pressed. Press again for each SHIFT function desired.
[1]: For entering the number 1
[2]: For entering the number 2
[3]: For entering the number 3
[4]: For entering the number 4
[5]: For entering the number 5
[6]: For entering the number 6
[7]: For entering the number 7
[8]: For entering the number 8
[9]: For entering the number 9
[SPACE]: For scrolling option list
[0]: For entering the number 0
[#/ENTER]: Starts programming mode;
Press to accept entries
7720P
PROGRAM
CONNECTOR
7720 PROGRAMMING TOOL
A
B C
1 2 3
D E
F
4 5 6
S T X
7 8 9
Enter
0 #
SHIFT KEY FUNCTION
[ESC]: Press to quit program mode; also can reset
programming defaults*
[]: Scroll up programming
[Y]: Press SHIFT-Y for "YES" answer
[A]: For entering letter A
[B]: For entering letter B
[C]: For entering letter C
[D]: For entering letter D
[E]: For entering letter E
[F]: For entering letter F
[S]: For entering letter S
[T]: For entering letter T
[X]: For entering letter X
No SHIFT function
No SHIFT function
No SHIFT function
11