GSMX4G / GSMXCN4G Installation and Setup Guide
The GSMX4G GSM Communicator (GSMXCN4G in Canada), herein referred
to as the communicator, easily connects to your security system's control
panel and sends alarms and messages to AlarmNet for subsequent transfer to
the central monitoring station. It can be mounted directly on the control
panel or remotely.
The new 4G connectivity brings faster GSM data transfers with lower latency
(response time); together it results in speedier data transfers.
The GSMX4G requires an AlarmNet account. For new installations,
please obtain the account information from the central station prior to
The GSMX4G communicates with AlarmNet using GSM (Global System for
Mobile) technology utilizing GPRS (General Packet Radio Service) as a
means of data transfer. If the GPRS part of the GSM cellular network is
unavailable, it will attempt to send a transmission via SMS (Short Message
Service) also known as a text message.
In addition to alarm reporting, the communicator provides two-way voice
communications with the central station (when used with Honeywell's AVS
Audio Verification System) and provides upload/downloading capability of
Honeywell's control panel data over the Internet (via the AlarmNet-G
network), using GSM (Global System for Mobile) technology.
UL / ULC
Two-way voice has not been evaluated by UL / ULC.
NOTE: Two-way voice is not compatible with Honeywell Commercial
Control Panels (such as the VISTA-128/250 series).
Reports fire, burg, and status messages via GSM.
Internal antenna provides additional security.
Simple programming using the 7720P programming tool or via the
AlarmNet Direct website.
Uses 2 way ECP communication with the control panel.
Sends reports in Contact ID format.
Supports remote control of alarm system via Remote Services
Allows uploading and downloading of control panel data via GSM.
Fully powered (primary and backup battery) from the control panel.
– 1 –