Registering Using The Test Message/Registration Switch; Registering Using The 7720P Programming Tool - Honeywell CDMA-X Installation And Setup Manual

Once the dealer assigns a login name and password, the customer will receive a "Welcome" e-mail message with their login
name along with some helpful information. The customer will receive another e-mail message with their password. They
will then be able to receive notifications, and access their system via the Total Connect website or using their cell
phone/Smartphone that supports GPRS and Text Messaging (SMS).

Registering Using the Test Message/Registration Switch

Initiate the registration sequence by clicking
the TEST MESSAGE / REGISTRATION switch
three times.
TEST MESSAGE /
REGISTRATION
Switch

Registering Using the 7720P Programming Tool

The interactive registration feature allows the installer to register the communicator through a series of keyboard
commands on the 7720P Programming Tool. This method of registration lets the installer monitor the registration
process.
Registering ...
Registration
SUCCESS
Possible Errors
Registration BAD
Timed Out
Registration BAD
Pri Sub ID BAD
Registration BAD
Pri ID – Need PIN
CDMA-X Installation and Setup Guide
Once the installation is complete, press the [Shift] plus the up arrow [↑] on the 7720P. The
registration message is sent and the unit waits for the acknowledgment.
If this is a new installation and the city, central station, and customer numbers have been
correctly entered, the communicator is registered and this message is displayed. The
communicator is now in full service and available for alarm reporting to the central station.
Displayed if no response to the registration request is received.
Indicates the city, central station, or customer number for the labeled account(s) is not
accepted. The ID information was either entered in error, or the central station failed to pre-
authorize programmed ID numbers with AlarmNet customer service.
Displayed if this is a repair/replacement, or an error was made in programming the Primary
account information of the communicator for an existing account. This prompt appears for 2
seconds. See the Replacing an existing communicator topic.
– 16 –