Honeywell GSMX4G Installation And Setup Manual page 18

GSMX4G / GSMXCN4G Installation and Setup Guide
PROMPTS ENTRY
7
Verify
Password
8
Exit Prog.
Mode?
(Y/N)_
9
Device
Mode
(ECP)_
OPTIONS
[0-9, A-F, Re-enter the password as
N, S, T, X, confirmation.
Y]
If the password doesn't match the
first entry, the following is
displayed followed by the "Exit
Prog. Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?"
prompt is displayed directly.
[Y], [N] Exits program mode.
[ESC] Press [N] to go back to Prompt 3.
Press [ESC] to load factory
defaults.
Refer to the Exiting the
Programming Mode topic.
• ECP Press the [space] key to scroll
through the modes of
• 4204
Press [ENTER] to select the
Emu
desired mode.
• Two
ULC NOTE: Must be ECP.
4204s
– 16 –
DESCRIPTION
operation.