Mounting The Module On The Wall - Honeywell GSMX4G Installation And Setup Manual

GSMX4G / GSMXCN4G Installation and Setup Guide
restore power to the communicator, control panel and AVS Audio
Verification System.)
2. Connect one end of the audio cable (5-pin connector) to the audio
connector located on the PC board in the communicator.
3. Route the audio cable to the connector on the AVS Base Unit and
connect the cable (4-pin connector).
4. Ensure the audio cable ends are secured with tie wraps to reduce
strain.

Mounting the Module on the Wall

1. Ensure control panel power (both AC and battery) is off, then remove
a suitable knockout on the top or side of the control panel cabinet.
NOTES:
• If in the wall wiring will be used, route the wiring through the
communicator's rear wiring access hole.
• If surface mounted wiring will be used, remove the
communicator's bottom knockout and use that to route the wiring.
• If using two-way voice, refer to the previous topic.
2. Open the communicator's cover. Remove the Hole Cap attached to
the plastic (trim as necessary), and snap it into the top opening of
the enclosure.
3. Secure the enclosure to the wall using both mounting holes.
Audio
Connector
AVS BASE UNIT
ON ON
1 2 3 4 1 2 3 4 5
– 8 –