Download  Print this page

Ecp Status Codes - Honeywell GSMX4G Installation And Setup Manual

Intellipath series 4g gsm communicator auto-selects optimum gsm path - 2g, 3g, or 4g
Hide thumbs

Advertisement

GSMX4G / GSMXCN4G Installation and Setup Guide
PROMPTS
ENTRY
45
only
Restore
Zn8 Y/N
2-4204
(Y)
46
only
Delay Zn8
(secs)
2-4204
(00)
47
Review?
Y/N

ECP Status Codes

The communicator sends status messages to the control panel to report
various failures. Some control panels, (e.g., VISTA-10P, VISTA-15P and
VISTA-20P Series) display these status codes on the keypad as "LngRng
Radio" followed by a 4-digit code. Commercial panels can supervise the
communicator by way of its ECP address, ex: 03. For example, if the
communicator is disconnected, if it's not registered, or the SIM is deactivated,
a "Check 803" will be displayed.
The control panel will display a fault message if any of the events listed
below occur.
Module lost communications with the control panel.
OPTIONS
[Y], [N]
Enables restore reporting for
zone 8.
[01-15]
Defines the reporting delay in
seconds for zone 8.
[00] = no
delay
[Y] =
Reviewing Programming
review
Mode Entries
[N] = exit
To review the programming
options (to ensure that the correct
entries have been made), press
[Y]. The programming prompts
are displayed again. Use the
up/down arrow keys to scroll
through the program fields
without changing any of the
values. If a value requires
change, simply type in the correct
value. When the last field is
displayed, the "REVIEW?"
prompt again appears.
To exit the programming
mode, press [N] in response to
the "REVIEW?" prompt, and refer
to Exiting Programming Mode
topic.
– 24 –
DESCRIPTION

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Honeywell GSMX4G

  Related Manuals for Honeywell GSMX4G

This manual is also suitable for:

Gsmxcn4g