Remote Services; Registering Using The Test Message/Registration Switch - Honeywell GSMX4G Installation And Setup Manual

GSMX4G / GSMXCN4G Installation and Setup Guide
• MAC ID and MAC CRC number (located on the box and inside the
communicator).
After the communicator is registered, you may log out of the AlarmNet Direct
website.

Remote Services

The dealer/installer will set up the customer account and define the events to
be notified of. These events match the output relay triggering events that
were programmed in the control panel.
At the AlarmNet Direct website, refer to the online "AlarmNet Direct User
Guide" for information on configuring the hardware and creating a Total
Connect web account for the customer.
For TC1 compatible communicators, 4204 Multi-Mode must be used.
For TC2 compatible communicators, Enhanced Reports must be enabled.
Once the dealer assigns a login name and password, the customer will receive
a "Welcome" e-mail message with their login name along with some helpful
information. The customer will receive another e-mail message with their
password. They will then be able to receive notifications, and access their
system via the Total Connect website or using their cell phone/Smartphone
that supports GSM/GPRS and Text Messaging (SMS).

Registering Using the Test Message/Registration Switch

Initiate the registration sequence by clicking
the TEST MESSAGE / REGISTRATION switch
three times.
TEST MESSAGE /
REGISTRATION
Switch
– 27 –