Programming The Module; Using The Alarmnet Direct Website - Honeywell GSMX4G Installation And Setup Manual

GSMX4G / GSMXCN4G Installation and Setup Guide
utilized, however DO NOT utilize a control panel knockout that is
being used for primary power.
6. Refer to the installation guide for the control panel, and complete the
ECP cable wiring.
7. Secure the wiring with ties as necessary.

Programming the Module

The GSMX4G requires an AlarmNet account. For new installations,
please obtain the account information from the central station prior to
programming.
You can program the communicator by one of the following methods:
•

Using the AlarmNet Direct website.

Using the 7720P Programming Tool.
•
Using the control panel's programming mode (for panels that
•
support this option) to access the communicator's programming.
NOTE: The prompts in this document reflect use of the 7720P Program-
ming Tool.
Using the AlarmNet Direct Website
To program the communicator via the website (if you are already signed up
for this service), go to: https://services.alarmnet.com/AlarmNetDirect/
If you are not signed up for this service, click on "Dealer Sign-Up" and follow
the instructions. Log in and follow the on-screen prompts. Please have the
following information available when programming the communicator:
Primary City ID (two-digit number), obtained from your monitoring
•
station.
• Primary Central Station ID (two-digit number), obtained from your
monitoring station.
• Primary Subscriber ID (four-digit number), obtained from your
monitoring station.
Communicator's MAC ID and MAC CRC number (located on the box
•
and inside the communicator).
After programming is complete, the communicator must be registered. Refer
to the Register the Module topic.
– 10 –