Honeywell GSMV4G Manuals

Table of Contents

• • 3

    Table of Contents

• 5

  SECTION 1: General Information

  • 5

    System Overview
    • 5

      Introduction
    • 5

      General Information
  • 5

    System Features
  • 6

    Encryption
  • 6

    Remote Services
  • 6

    Modes of Operation
    • 6

      ECP Mode
    • 7

      Zone Trigger Mode
    • 7

      4204 Mode And Two-4204 Mode
  • 7

    Supervision Features
    • 8

      Antenna
  • 9

    Specifications
  • 10

    Compatibility
  • 10

    Compliance

• 11

  SECTION 2: Mounting and Wiring

  • 11

    Determine the Signal Strength and Select a Location
  • 12

    Mounting the Communicator
    • 12

      Mounting Procedure, GSMV4G (No Rear Tamper Switch)
    • 13

      Mounting Procedure, GSMVCN4G (With Rear Tamper Switch)
  • 14

    Wiring the Communicator
    • 14

      Wiring for Two-Way Voice
    • 15

      Wiring for ECP, 4204 and Two-4204 Modes
    • 15

      Wiring for Zone Trigger Mode
    • 16

      Wiring the Fault Relay
  • 17

    Power Connections and Options
    • 17

      Powering the Communicator
    • 18

      Backup Battery Connection
    • 18

      Initial Power-Up Sequence

• 19

  SECTION 3: Programming the Communicator

  • 19

    General Information
    • 19

      Using the Alarmnet Direct Website
    • 19

      Using a 7720P Programming Tool
    • 20

      Using the Control Panel Programming Mode
    • 21

      Programming Conventions
  • 21

    ECP Mode Programming
    • 25

      ECP Status Codes
  • 26

    Alternative Mode Programming (Zone Trigger, 4204 and Two-4204)
    • 26

      Zone Trigger Mode
    • 26

      4204 Emulation Mode
    • 26

      4204 Emulation Mode Options
  • 28

    Alternative Mode Programming
  • 36

    Exiting Programming Mode
    • 36

      Setting Factory Defaults

• 37

  SECTION 4: Registration

  • 37

    Registering the Communicator
    • 37

      Registering Through Alarmnet Direct Website
    • 38

      Register Using the Tamper Switch
    • 38

      Register Using the Programming Tool
    • 39

      Replacing an Existing Communicator
    • 39

      Register By Phone

• 41

  SECTION 5: Programmer Keyboard Commands

  • 41

    Programmer Keyboard Commands
    • 41

      Identification Displays
    • 42

      GSM Status Displays
    • 44

      System Status Displays

• 47

  Appendices

• 47

  Appendix A: Summary of LED Operation

• 49

  Appendix B: Central Station Messages

• 51

  Appendix C: Glossary