Download  Print this page

Central Station Messages - Honeywell GSMX4G Installation And Setup Manual

Intellipath series 4g gsm communicator auto-selects optimum gsm path - 2g, 3g, or 4g
Hide thumbs

Advertisement

GSMX4G / GSMXCN4G Installation and Setup Guide
[Shift]
Registering
...
[↑]
(UP
arrow)
[↓]
Enter PIN#
(DN
arrow)
[0]
Force
Server
Update?
Y/N
[ENTER] Strt Prog
Mode?
Y/N_

Central Station Messages

The following messages are sent to the Central Station by AlarmNet for the
conditions listed below. NOTE: The control panel sends its own general code
(E353) for a trouble condition.
Alarm Condition
Alarm Code
Power On / Reset
E339 C08xx
(xx=device address)
ECP Supervision
E355 C0000
Communication Path
Supervision
Test
5555 5555 9
Registration
Registers a programmed communicator with
AlarmNet.
Registration with PIN for Replacement
Module
Registers a replacement communicator with
AlarmNet, once programmed, using the existing
PIN #.
Force Upload of Configuration File to
Server
Pressing [Y] will force the device to upload its
entire configuration file to the server.
Pressing [N] cancels the operation.
NOTE: If the communicator is not initialized
when you enter this command, the following
screen will be displayed:
Cannot Upload
Try Later! _
Wait for the SIGNAL (green) LED to light,
indicating the communicator has completed its
initialization, and try again.
Enter Program Mode
Press [Y] to enter program mode; otherwise,
press [N].
ECP Mode
Restore Code
Alarm Code
5551 5555 6
R355 C0000
5555 5515 5
R350 C0951
5555 5555 9
– 34 –
4204 Modes
Restore Code
5555 5535 5
5555 5553 5

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Honeywell GSMX4G

  Related Manuals for Honeywell GSMX4G

This manual is also suitable for:

Gsmxcn4g