Mounting The Module On The Control Panel - Honeywell GSMX4G Installation And Setup Manual

GSMX4G / GSMXCN4G Installation and Setup Guide
SIGNAL LED (green)
ON - Satisfactory Signal
BLINKING - Marginal Signal
OFF - Unsatisfactory Signal
3. Verify the SIGNAL LED (green) remains steady for a few minutes,
then mark that mounting position. Turn power off.

Mounting the Module on the Control Panel

1. Ensure power to the control panel (both AC and battery) is off, then
remove the knockout on the top right of the control panel cabinet.
2. Open the communicator cover. Remove the Hole Cap attached to the
plastic (trim as necessary), and snap it into the top opening of the
enclosure.
3. Remove the bottom knockout on the enclosure for the threaded
mount. Then install the threaded mount so it snaps into the plastic
retaining tabs. Mount the communicator assembly on the cabinet's
knockout, and fasten with the locking nut.
– 6 –
Hole Cap