Led And Wiring Information - Honeywell GSMX4G Installation And Setup Manual

LED and Wiring Information

LED
REG ON – Module is NOT registered with AlarmNet.
(green) OFF – Module is registered with AlarmNet.
FAST BLINK – Download session with Compass in progress.
SLOW BLINK – In unison with yellow LED – Registration in progress.
TX/RX ON – Message transmission pending.
(yellow) QUICK PERIODIC BLINK - Normal
FAST BLINK – Message waiting for network ACK.
SLOW BLINK – In unison with green LED – Registration in progress.
FAULT ON – No contact with network.
(red) OFF– Normal.
SLOW BLINK – Loss of communication with the panel (ECP fault).
FAST BLINK – No network contact AND loss of communication with the
control panel.
SIGNAL ON – Minimum required signal strength is present.
(green) BLINKING – Marginal signal strength is present.
OFF – Installation is not recommended.
ALL FAST BLINK – Hardware Error.
REG
TX/RX
FAULT
SIGNAL
ECP Cable
TEST MESSAGE/
REGISTRATION
Switch
Audio
Connector
PANEL DATA OUT - Yellow
To ECP Bus on
AUX PWR (+12V) - Red
control panel
circuit board.
PANEL DATA IN - Green
DESCRIPTION
GND - Black
FACTORY
USE ONLY
TECH SUPPORT
USE ONLY