Table of Contents
Advertisement
Registering Using the 7720P Programming Tool
The interactive registration feature allows the installer to register the communicator through a series of keyboard
commands on the 7720P Programming Tool. This method of registration lets the installer monitor the registration
process.
Registering ...
Registration
SUCCESS
Possible Errors
Registration BAD
Timed Out
Registration BAD
Pri Sub ID BAD
Registration BAD
Pri ID – Need PIN
Replacing an existing communicator
This prompt appears after pressing the down arrow [↓] on the 7720P. Enter a 4-digit
Enter PIN#
alphanumeric PIN number provided by your central station, your dealer or an authorized
AlarmNet representative.
Press the [ENTER] key.
The registration message is sent and the unit waits for acknowledgement.
Registering ...
If the PIN is valid, the new communicator is registered and the old unit unregistered.
Registration
Additionally, AlarmNet sends a substitution alarm to the central station.
SUCCESS
If you entered an invalid PIN, the appropriate message is displayed depending on which account
Registration BAD
number is being replaced (see above for exact wording). The registration process is repeated.
NOTE: Each attempt causes a substitution alarm to be sent to the central station.
Registering by Phone
You can register the communicator by calling the AlarmNet Support at 1-800-323-4576 (Monday–Friday 8:30 am to 9:00
pm, Saturday 9:00 am to 5:30 pm ET). You will need the following information:
•
MAC ID and CRC (located on the box and inside the communicator).
•
Subscriber information (provided by the central station), including a city code, CSID, and subscriber ID.
•
When instructed to do so, triple click the TEST MESSAGE / REGISTRATION switch.
LTE-X Series Installation and Setup Guide
Once the installation is complete, press the [Shift] plus the up arrow [↑] on the 7720P. The
registration message is sent and the unit waits for the acknowledgment.
If this is a new installation and the city, central station, and customer numbers have been
correctly entered, the communicator is registered and this message is displayed. The
communicator is now in full service and available for alarm reporting to the central station.
Displayed if no response to the registration request is received.
Indicates the city, central station, or customer number for the labeled account(s) is not
accepted. The ID information was either entered in error, or the central station failed to pre-
authorize programmed ID numbers with AlarmNet customer service.
Displayed if this is a repair/replacement, or an error was made in programming the Primary
account information of the communicator for an existing account. This prompt appears for 2
seconds. See the Replacing an existing communicator topic.
– 13 –
Hide quick links:
Advertisement
Table of Contents
