GSMX4G / GSMXCN4G Installation and Setup Guide
To begin programming the
communicator, press [Y] and go to
Prompt 9: "Device Mode."
To create a password if none has
been assigned, press [N] and go to
Prompt 4: "Create Password?."
To change an existing password,
press [N] and go to Prompt 5:
Passwords can be used to protect
account and programming
If no password has been assigned,
this prompt appears after
pressing [N] at the "Program
If a password is desired, press [Y]
and go to Prompt 6: "Enter
If a password has already been
assigned, this prompt appears
after pressing [N] at the
"Program Device?" prompt.
Press [Y] if you want to change
NOTE: To clear an existing
password, without entering a new
one, answer [Y] to the "Change
Password?" prompt, then press
the [Enter] key when prompted
for the new password and its
This prompt is displayed if [Y]
N, S, T, X,
was pressed in Prompt 4 or 5.
Enter a 4-digit password
(0-9, A-F, N, S, T, X, Y).
– 15 –