Using The Alarmnet Direct Website; Using A 7720P Programming Tool - Honeywell IntelliPath Series Installation And Setup Manual

IGSMHS4G Installation and Setup Guide

Using the AlarmNet Direct Website

To program the communicator via the website (if you are already signed up for this service),
go to:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx
If you are not signed up for this service, click on "Dealer Sign-Up.
Log in and follow the on-screen prompts.
Please have the following information available when programming the communicator:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on the box and inside the communicator)
After programming is complete, you must transfer the data to the communicator and the
communicator must be registered. Refer to Section 4: Registration, for further instructions.

Using a 7720P Programming Tool

Connect the 7720P Programming Tool as shown below. The communicator powers the 7720P
Programming Tool via the programming jack, and automatically senses the presence of the
7720P when it is plugged in.
Each key of the 7720P has two possible functions: a normal function and a Shift function.
To perform a normal key function, simply press the desired key.
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. The table below
lists each normal and shift key function.
KEY
BS / ESC
↓ / ↑
N / Y
SHIFT
1 / A
2 / B
3 / C
4 / D
3-2
7720P Programming Tool Connection
Table 3-1. 7720P Normal and Shift Key (shift LED lit) Functions
NORMAL KEY FUNCTION
[BS]: Press to delete entry
[↓]: Scroll down programming
[N]: Press for "NO" answer
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key
is pressed. Press again for each SHIFT function desired.
[1]: For entering the number 1
[2]: For entering the number 2
[3]: For entering the number 3
[4]: For entering the number 4
SHIFT KEY FUNCTION
[ESC]: Press to quit program mode; also can reset
programming defaults*
[↑]: Scroll up programming
[Y]: Press SHIFT-Y for "YES" answer
[A]: For entering letter A
[B]: For entering letter B
[C]: For entering letter C
[D]: For entering letter D