Honeywell GSMX4G Installation And Setup Manual page 35

GSMX4G / GSMXCN4G Installation and Setup Guide
CNtry NetW LAC
xxx xxx xxxxx
Cell BaseST Chan
xxxx xxxx xxx
Second Site RSSI
Available
[S]
ECP Flt
OK
[T]
Test Msg
Sent
[X]
Reset CPU
Y/N
Status Display Screen 3
CNtry – Country Code
NetW – Network Code
LAC – Local area code
Press the [space] key to get to the next
screen.
Press the [backspace] key to go to the
previous field.
Status Display Screen 4
Cell – Base Station ID
BaseST – Base Station Antenna Sector
Chan – Control Channel in use
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the
previous field.
Status Display Screen 5
Secondary Site RSSI availability. Available
or Not Available will be displayed.
Press the [space] key to go to Status Display
Screen 1.
Press the [backspace] key to go to the
previous field.
ECP Mode
Displays the mode of operation and system fault
status.
Flt – Represents communicator faults:
OK = Normal, No fault.
G = No network connectivity over GSM and fault
time has expired.
g = No network connectivity over GSM and fault
time has NOT yet expired.
Test Alarm
Sends a Test alarm to AlarmNet. Functional for
a registered communicator only. If the device is
not registered, a message is displayed indicating
that the command cannot be executed.
Reset the communicator.
Pressing [N] returns to normal mode.
Pressing [Y] resets the device.
– 33 –