Honeywell GSMX4G Installation And Setup Manual page 20

GSMX4G / GSMXCN4G Installation and Setup Guide
PROMPTS ENTRY
NOTE: Account information is provided by the central station administrator.
12
Primary City
ID
(??)_
13
Primary CS
ID
(??)
14
Primary Sub
ID
(????)
15
En. 2nd CS
Y/N
(N)
16
Device
Address
(03)_
Setting up the Remote Access Feature
Remote Access enables the user to control the security system using a web browser.
This feature must be configured at the AlarmNet Direct website as follows:
• Remote Access must be enabled by selecting "Enabled" at the Remote Access
prompt.
• A keypad address must be enabled in the communicator in order for it to commu-
nicate with the control panel.
• At the "Keypad Type" prompt, select the appropriate Keypad.
OPTIONS
The address used must also be
enabled as a 4204 relay module in
Vista and First Alert control
panels.
[01-99]
Enter the 2-digit primary city ID,
01-99 (decimal).
[01-FE] Enter the 2-digit primary central
station ID number, 01-FE (HEX).
[0001- Enter the 4-digit subscriber
9999] account number, 0001-9999
(decimal).
[Y], [N] Applicable only if the control
panel supports Central Station #1
and #2 Category Enable reporting
for the communicator (or LRR)
device (e.g., VISTA-128BP,
FA1660C, etc.).
Used if reporting to a second
central station is desired.
[01-30] The GSMX4G communicates with
the control panel as a commu-
nicator (or LRR) device. Enter
the ECP device address.
NOTE: When programming the
control panel, enable the commu-
nicator's (or LRR) output.
– 18 –
DESCRIPTION